Leading 10 usual forklift accidents ， forklift procedure should pay attention to these issues ！.

Don't undervalue the forklift at the office. If the procedure is not good, there will be serious accidents in minutes, and there are several mishaps including forklifts.

Case 1: The forklift freight obstructed the chauffeur's view, and the person in front might not be found, leading to a rolling crash.
Instance 2: In order to maintain the balance of the forklift when raising heavy items, the staff members used their body weight as the counterweight, which almost caused casualties.
Case 3: The width of the forklift freight goes beyond the permitted width of the route and hangs on the roadside rack, which almost causes an crash.
Instance 4: Forklift is speeding and surrender throughout a turn.
Case 5: The forklift motorist did not observe the pedestrian, and the pedestrian did not observe the forklift.
Case 6: The forklift raises the workers unlawfully, the forklift vehicle driver does not wear the seat belt, the forklift lifter drops and the chauffeur is squashed when the forklift surrender.
Instance 7: The forklift vehicle driver did not put on a safety belt and dropped from the lorry when it surrendered and was crushed.
Forklift operation must take note of these matters ：.

Start.
1. Prior to starting, observe the environments, and after confirming that there are no challenges that impede the safety of driving, honk the horn initially and then begin.
2. For lorries with hydraulic ( atmospheric pressure) brakes, the brake hydraulic stress ( atmospheric pressure) scale need to be safe prior to starting.
3. When the forklift begins with a tons, the motorist must first confirm that the tons is secure and reliable.
4. The begin should be sluggish and steady.

Driving.
1. When driving, the elevation between the bottom end of the fork and the ground need to be kept at 300mm-400mm, and the pole ought to be tilted in reverse. .
2. Do not lift the fork too expensive when driving. When going into and leaving the work website or while driving, take care that there will certainly be no challenges in the sky. When the load is taking a trip, the fork has to not be elevated too expensive, which will affect the security of the forklift. .
3. After unloading, the fork must be reduced to the typical driving placement prior to driving. .
4. When transforming, if there are pedestrians or vehicles close by, the driving signal should be released first. High-speed sharp turns are forbidden. High-speed doglegs will cause the vehicle to shed lateral security and tip over. .
5. When the forklift is downhill, it is strictly prohibited to switch off the flame and slide, and it is prohibited to brake suddenly while driving with loads unless there are special scenarios.
6. When the forklift is running, it must obey the web traffic rules in the manufacturing facility and must keep a certain security range from the lorry ahead. .
7. When the forklift is running, the lots needs to remain in the most affordable setting that does not prevent the driving, and the gantry needs to be correctly tilted back. The lots shall not be raised other than when piling or filling. .
8. The elevation of the lots must not obstruct the motorist's view. In unique circumstances, when the thing impacts the forward vision, drive at a low speed when reversing.
9. It is forbidden to activate the ramp, nor to drive across the ramp. .
10. The safe driving speed of the forklift in the manufacturing facility location is 5 km/h, and it has to drive safely at a reduced rate when going into the production workshop area. .
11. When the forklift is lifted, raised or driven, it is prohibited for personnel to base on the fork to hold products and play a stabilizing function. .
12. If troubles Electric Forklift Truck for Warehouse are located, they will be repaired and reported in a prompt way, and they will never operate with health problems or conceal them.

filling and dumping.
1. When fork-loading products, the range in between the two forks need to be changed as required to make the tons of the two forks well balanced and not manipulated, and one side of the item ought to protest the shelf. .
2. It is forbidden to deal with a solitary fork or utilize a fork top or draw. In unique scenarios, security indication need to be established to advise bordering pedestrians. .
3. In the process of packing and dumping items, the forklift needs to be stopped with the brake. .
4. The rate of the car need to be slow and stable. Beware not to roll the wheels on the dunnage, so as not to extend the rolled items and injure individuals. .
5. When using a fork to fork the goods, the fork needs to be as deep as possible under the tons, and it ought to be noted that the fork pointer should not touch other items or objects. The load Electric Forklift Truck for Warehouse ought to be maintained with very little back tilt of the gantry to make sure that the tons does not glide backwards. The mast can be slanted onward slightly when the tons is decreased to allow for simple positioning of the load and extraction of the forks. .
6. It is prohibited to fork items at high speed and hit difficult things with the fork head. .
7. When the forklift is working, it is forbidden for people to loaf the fork, so regarding avoid the collapse of the goods and hurt people. .
8. Overwhelming is banned, and it is prohibited to utilize forks to raise employees to take part in high-altitude operations to avoid high-altitude falling mishaps. .
9. It is not enabled to utilize the brake inertia to slide, place, round or roll things. .
10. It is not permitted to use forks to pick, turn pallet unload.

Leaving .
1. It is prohibited to leave the forklift when the products on the fork are in the air. Before leaving the forklift, you need to discharge the goods or reduced the fork framework.
2. Draw the emergency brake manage to dead or dispirit the hand brake button.
3. The engine is shut off and the power is removed. (Except for special scenarios, such as the motorist does not leave the automobile's view and does not surpass 1 min).
4. Eliminate the key. .

Forklift Operation Precautions.
1. Before and after the forklift operation, the look needs to be examined, and gas, lubricating oil and cooling water should be included.
2. Examine the safety and security efficiency of starting, running and braking.
3. Examine whether the lights and horn signals are full and efficient.
4. During the operation of the forklift, examine whether the stress and temperature are normal.
5. After the forklift is running, the exterior leak ought to also be checked and the seals need to be changed in time.

Forklift Safety Operation Specifications.
1. You should check prior to leaving the cars and truck;.
2. When you come across someone before you throughout driving, you should send out a signal at a distance of 5 m;.
3. The driving speed in the factory does not go beyond 5 km/h;.
4. When driving, the low point of the freight must be 0.3 m ~ 0.4 m above the ground;.
5. The transforming must not be too sharp to stop the tendency of "free switching";.
6. Running up and down the incline should be slow-moving and uniform, and no activating the slope is permitted.
7. Do not drive across the slope. When the gradient is more than 10%, the automobile should be driven in reverse when going downhill;.
8. When the forklift workers carry the goods and progress, if they encounter big or hefty goods and most likely to the driver's line of vision, they should take the turning around workout
.
The "Eight Prohibitions" ought to be adhered to in the operation.
1. Single fork procedure is not allowed.
2. It is not enabled to raise the goods for long distance driving.
3. It is not enabled to grab the goods by handing over the pallet with the fork.
4. It is not permitted to straight shovel chemicals, flammables and other harmful chemicals with forks.
5. It is not permitted to use inertia force to grab the goods.
6. It is not allowed to utilize stopping force to expatriation round or easy-to-roll things.
7. It is not allowed to bring people to service the pallet or fork, and it is purely forbidden to stand under the fork after the fork is increased.
8. Do not drive side to side on inclines
.
Car parking is not allowed under the list below problems.
1. Contours, slim roads, railway crossings;.
2. Sections with a longitudinal slope above 5%.
3. When there is an barrier on one side of the roadway, the contrary side of the section with the same length as the challenge must be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844